Controls & Instrumentation
>
If you have variables on your plant that you want to control, monitor & record, let TIBS take control. We have years of practical experience in being able to solve your monitoring & control problems. We can provide pneumatic & electronic instrumentation including:
Pressure Gauges, Control Valves, Damper Actuators, Primary flow devices, Temperature, Pressure flow & level sensors, Controllers and Recorders.



 TIBS can:
  • Supply direct replacement instruments,
  • Interface into your existing C&I schemes,
  • Provide you with a bespoke C&I solution,
  • Design, supply & install control panels, and
  • Provide experienced installation & commissioning engineers.


 Typical boiler control application
"Shrink & swell" is a boiler control problem usually associated with sudden high process steam demands that cause rapid water level changes within the steam drum. If the water level control system is not able to anticipate the changes early enough then serious damage to the plant will occur. This phenomenon can be controlled by implementing a three element drum level control philosophy. TIBS have successfully designed, installed & commissioned many three element drum level control systems world-wide.

 Boiler control scheme conversions
TIBS can convert pneumatic boiler control schemes to modern electronic boiler control packages.

 Burner management systems
TIBS can provide burner management systems (BMS) for oil, gas or dual fuel applications.

 SCADA systems
TIBS can design, supply, install & commission distributed control schemes making use of propriety SCADA software & programmable controllers. Typical applications could be remote monitoring & control of district heating schemes, boiler plant control & energy monitoring.
 Electrical trace heating
TIBS can design, supply & install electrical trace heating & thermal pipe insulation for fuel oil pipe lines.

 Motor control
TIBS can supply all your electric motor needs from replacement motors, starters, motor starter replacement motors, motor starter suites & variable drives.

 Plant condition monitoring
TIBS can design & implement condition monitoring & planned maintenance systems to suit your individual needs. These systems can be simple & routine or extended into a more sophisticated management tool. For more information about this, or any other C&I application, please contact TIBS.